Cattle Hoof Block Adhesive – Two-Part Polyurethane, 200 ml

This 200 ml two-part polyurethane hoof block adhesive is intended for bonding wooden or rubber blocks to a cattle hoof claw, helping reduce pressure on the opposite claw as part of professional hoof care.

Product details

• Adhesive type: Two-component polyurethane (urethane).
• Capacity: 200 ml dual-chamber cartridge.
• Supplier references: HOOFREP5627 / 5627W.
• Component colours: Part A clear; Part B amber.
• Closure: Twist-off cap.
• Mixing system: Cartridge and lock-in mixing tip, designed to avoid separate hand mixing.
• Country of origin: China.

Supplier-listed timing and storage

• Working time: Approximately 25 seconds at 20°C.
• Set time: Approximately 30 seconds.
• Bonding time: 2–3 minutes.
• Shelf life: Supplier states 12 months when stored at 20–30°C; check the cartridge expiry date.
• Before use: Supplier recommends keeping the cartridge around 20°C. Performance below 18°C has not been independently confirmed.

Working, setting and bonding times are different stages and are not a confirmed full-cure or weight-bearing time. Follow the manufacturer's instructions for the actual conditions and application.

Compatibility and safe use

The supplier describes compatibility with standard 200 cc applicators. Confirm the cartridge dimensions, dispensing ratio and mixing-tip connection before purchase; the required ratio and compatibility with specific guns or nozzles are not confirmed.

Use under the guidance of a trained hoof-care professional. Obtain and follow the manufacturer's safety data sheet and instructions for ventilation, protective equipment, preparation and curing. Do not rely on the supplier's unverified claim that the adhesive is fume-free, odour-free or safe in enclosed areas.

The supplier also lists footwear and leather bonding among its uses, but suitability for a particular material must be confirmed. Horse-hoof suitability and whether an applicator, blocks or mixing tips are included have not been confirmed.